Swimming Pool Time Switch -Pool Timer Installation

Pool Timers Installation

Precision direct time switch replacements (movements only) are so easy to install; the only tool required is a screwdriver. No need to remove or replace the existing enclosure — just follow these instructions.

1. Turn power to pool timer off. Safest and easiest way is to switch off the appropriate breaker in the electrical distribution panel box.

2. Remove insulated wire cover from the pool timer and disconnect the wires. It is most important to mark the wires or if color coded, to note where each wire came from. Each terminal board has numbers on their screw terminals and these should match the manufacturer’s electrical label on the inside of the front enclosure door. Note line, load and neutral terminals and wires.

3. Remove the inoperative pool timer movement from the box. Each manufacturer has its own method of doing this. Basically, the movement slides in so there is some side or top support from the enclosure and then snaps into position with a spring loaded clip or bracket. Note exactly how the clock you are removing is mounted.

4. Install the Precision pool timer replacement movement in the reverse sequence as #3, (above).

Pool Timers
Model

Replacement Pool Timers - Timer Only

24-Hour Pool Timers with Enclosure

Pool Timer with Heater Delay Circuit or "Fireman's Switch"

Two-In-One Swimming
Pool Timer Switch with Enclosure

Spring Wound In Wall Timers 15/30/60 min. or 12 hr.

Overview

About our pool timers

Wiring Diagrams

Pool timers
reference guide

Pool timers Installation

Pool Timers Installation (continued)

5. Compare the old electrical wiring diagram on the cover door with the Precision wiring diagram provided. Rewire the pool timer noting where line, load and neutral terminals are. Tighten down screws in each terminal so wire is secure. Replace insulator cover over wiring section of the terminal board.

6. Follow the instructions for setting the pool timer to operate as follows:

Our terminal is furnished with (2) sets of on/off trippers. Unless you are going to turn on & off twice in a 24 hour period, only one set is necessary. Since you are replacing a pool timer, you should probably set the on/off trippers to the time schedule you have been successfully using. Loosen up thumb screw in tripper and slide around dial to the time location desired. Note black tripper is “off” and silver color for “on”. Tighten screw in trippers (both on & off). Pull dial out and rotate so time of day on dial is positioned under center pointer, and let dial snap back into running position. Check clock slider in regard to on and off switch position. Slide into proper position.

7. Turn power panel breaker on and you are back in operation.

Important Clarification - Precision Multiple Controls, Inc. does NOT sell Intermatic® timers. Precision manufactures and sells their own timers with brackets that allow them to fit directly into an Intermatic® time switch enclosure. Intermatic® is the registered trademark of Intermatic Corporation - Spring Grove, IL USA

pool timers
Supplying high quality pool timers to the swimming pool market for over 40 years.
All pool timers are U.L. listed 40 amps.

Our pool timers product line includes:

Direct replacement Swimming Pool Timers.

Precision Swimming Pool Timers with “Fireman’s Switch”.

General Purpose 24 Hour Pool Timesr with NEMA III weatherproof enclosure.

Swimming Pool Timers with Heater Delay Circuit.
pool timer

pool timers
pool timer
swimming pool timers
swimming pool timer
Precision replacement timers
pool time switch
Precision replacement pool timers
Precision replacement pool timer

Compatible Series Precision's Replacement Pool Timers
General Purpose 24-Hour Pool Timers with Non-Corrosive Enclosure
2 Circuit Swimming Pool Time Switch with Non-Corrosive Enclosure
Two-In-One Swimming Pool Timer Switch with Non-Corrosive Enclosure
About our pool timers
Swimming Pool Timer Wiring Diagrams